3Com 7757 Configuration Manual page 856

856 C 78: B S
HAPTER ASIC
Displaying Debugging
Status
C & D
YSTEM ONFIGURATION EBUGGING
Figure 228 Debugging information output
Debugging information Debugging information
Protocol debugging switches Protocol debugging switches
Terminal display switches Terminal display switches
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Table 669 Enable debugging and terminal display
Operation
Enable system
debugging
Enable terminal display
for debugging
Table 670 Display the current debugging status in the system
Operation
Display all enabled
debugging on the
specified device
ON ON OFF OFF
OFF OFF
Command
debugging { all [ timeout
interval ] | module-name
debugging-option }
terminal debugging
Command
display debugging [ interface
interface-type interface-number ]
[ module-name ]
ON ON
ON ON
Description
By default, all debugging is
disabled in the system.
Because the output of debugging
information will affect the
efficiency of the system, disable
your debugging after you finish
it.
By default, terminal display for
debugging is disabled.
Description
You can execute the display
command in any view.