Configuring Redirect - 3Com 7757 Configuration Manual

Configuration Example

Configuring Redirect

Configuration
Prerequisites
Configuration Procedure
When a switch is connected to a RADIUS server, if the switch does not support
■
the inbound TP or outbound TP configured on the RADIUS server, the TP
configuration will be ignored on the switch.
GigabitEthernet 2/0/1 of the switch is accessed to the 10.1.1.1/24 network
■
segment
Perform TP on the packets from the 10.1.1.1/24 network segment and the rate
■
of TP is set to 128 kbps
The packets beyond the specified traffic are forwarded after their DSCP
■
precedence is marked as 56
Configuration procedure:
<SW7750> system-view
[SW7750-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[SW7750-acl-basic-2000] quit
[SW7750] interface GigabitEthernet 2/0/1
[SW7750-GigabitEthernet2/0/1] qos
[SW7750-qosb-GigabitEthernet2/0/1] traffic-limit inbound ip-group 20
00 kbps 128 exceed remark-dscp 56
Refer to "Redirect" on page 663 for the introduction to redirect.
ACL rules used for traffic identifying are defined. Refer to "Choosing ACL
■
Mode for Traffic Flows" on page 639 for defining ACL rules
The port that the packets are redirected to is specified
■
The ports that needs this configuration are specified
■
Table 544 Configure redirect
Operation
Enter system view
Enter Ethernet port view
Enter QoS view
Configure redirect
Display the parameters for
traffic redirect
Display all the QoS settings of
the port
acl-rule: Applied ACL rules which can be the combination of various ACL rules.
The way of combination is described in Table 541.
Command
system-view
interface interface-type
interface-number
qos
traffic-redirect inbound
acl-rule [ system-index
system-index ] { cpu |
interface interface-type
interface-number }
display qos-interface
[ interface-type
interface-number ]
traffic-redirect
display qos-interface
[ interface-type
interface-number ] all
Configuring Redirect 673
Description
-
-
-
Required
Optional
You can execute the display
command in any view.