Transit Node Configuration - 3Com 7757 Configuration Manual

Transit Node
Configuration
Configuration
Prerequisites
Transit Node
Configuration Tasks
<SW7750> system-view
[SW7750] rrpp domain 1
[SW7750-rrpp-domain-1] control-vlan 4092
[SW7750-rrpp-domain-1] ring 1 node-mode master primary-port GigabitE
thernet2/0/1 secondary-port GigabitEthernet2/0/2 level 0
[SW7750-rrpp-domain-1] timer hello-timer 2 fail-timer 7
[SW7750-rrpp-domain-1] ring 1 enable
[SW7750-rrpp-domain-1] quit
[SW7750] rrpp enable
[SW7750] display rrpp brief
[SW7750] display rrpp verbose domain 1
[SW7750] display rrpp statistics domain 1
The switch ports connecting the Ethernet rings have been configured as trunk
ports. All ports allow data VLAN packets to pass. And STP has been disenabled on
all the ports connecting the Ethernet rings.
The following table describes the transit node configuration tasks.
Table 707 Configure a transit node
Operation
Enter system view
Create an RRPP domain, and
enter RRPP domain view
Specify a control VLAN for
the RRPP domain
Specify the current switch as
the transit node of a ring,
and specify the primary port
and the secondary port of
the node
Enable an RRPP ring
Return to system view
Enable RRPP
Display the brief information
of all RRPP domains
configured on the switch
Display RRPP configuration
details on the switch
Display the RRPP packet
statistics on the switch
Clear the RRPP statistics
information
Command
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode transit
[ primary-port pri-port ]
[ secondary-port sec-port ] level
level-value
ring ring-id enable
quit
rrpp enable
display rrpp brief
display rrpp verbose domain
domain-id [ ring ring-id ]
display rrpp statistics domain
domain-id [ ring ring-id ]
reset rrpp statistics domain
domain-id [ ring ring-id ]

Transit Node Configuration

Description
-
Required.
The command prompt
of RRPP domain view
depends on the
domain-id you input.
Required
Required.
Level 0 identifies the
primary ring and level 1
identifies a subring.
Required
-
Required
Optional.
You can execute the
display command in
any view
Optional
You can execute the
reset command in user
view.
911