3Com 7757 Configuration Manual page 141

Configuring IPX SAP
to forward an IPX packet. A longer delay means slower forwarding whereas a
shorter delay means faster forwarding.
By importing routes, different routing protocols can share their routing
information. Note that IPX RIP imports only active static routes; inactive static
routes are neither imported nor forwarded.
Enabling IPX SAP
After IPX is enabled on VLAN interfaces, the system enables SAP automatically.
You can configure SAP parameters and service information as needed.
Table 88 Configure IPX SAP
Operation
Enter system view
Enable IPX
Enter VLAN interface view
Configure an IPX network
number for the VLAN
interface
Enable IPX SAP
Configuring IPX SAP
In a large network, one IPX SAP broadcast consumes enormous bandwidth
resources. By configuring an appropriate SAP update interval, you can reduce the
bandwidth waste. Make sure that all servers and switches on the network have
the same SAP update interval to avoid the situation where the switches mistake an
operating server for a failed one.
The aging period of IPX SAP is a multiple of the IPX RIP update interval. You can
set multiple update intervals as an aging period.
Table 89 Configure IPX SAP
Operation
Enter system view
Enable IPX
Configure the update interval
of IPX SAP
Command
system-view
ipx enable
interface Vlan-interface
vlan-id
ipx network network
undo ipx sap disable
Command
system-view
ipx enable
ipx sap timer update seconds
IPX Configuration 141
Description
-
Required
IPX is disabled by default
-
Required
By default, the system does
not assign network numbers
to VLAN interface. That is,
IPX is disabled on all the
VLAN interfaces
Required
By default, SAP is enabled as
soon as IPX is enabled on
the VLAN interface
Description
-
Required
IPX is disabled by default
Optional
By default, the update
interval of IPX SAP is 60
seconds