Console Port Login Configuration - 3Com 7757 Configuration Manual

Console Port Login
Configuration
Common Configuration
Figure 4 Set port parameters
3 Turn on the switch. You will be prompted to press the Enter key if the switch
successfully completes POST (power-on self test). The prompt (such as <SW7750>)
appears after you press the Enter key.
4 You can then configure the switch or check the information about the switch by
executing the corresponding commands. You can also acquire help by type the ?
character. The commands available on a switch are described in the related
module of the command manual.
Table 12 lists the common configuration of Console port login.
Table 12 Common configuration of Console port login
Configuration
Console port Baud rate
configuration
Check mode
Stop bits
Data bits

Console Port Login Configuration

Remarks
Optional
The default baud rate is 9,600 bps.
Optional
By default, the check mode of the Console port is
set to "none", which means no check bit.
Optional
The default stop bits of a Console port is 1.
Optional
The default data bits of a Console port is 8.
37