Displaying Route Capacity Configuration - 3Com 7757 Configuration Manual

388 C 38: R
HAPTER OUTE
Enabling/Disabling
Automatic Protocol
Connection Recovery
Displaying Route
Capacity
Configuration
C C
APACITY ONFIGURATION
Table 315 Set the lower limit and the safety value of switch memory
Operation
Enter system view
Set the lower limit and the
safety value of switch
memory
n
The safety-value must be greater than the limit-value.
Table 316 Enable automatic protocol recovery
Operation
Enter system view
Enable automatic
protocol recovery
Disable automatic
protocol connection
recovery
c
CAUTION: If automatic protocol recovery is disabled, the broken OSPF or BGP
connection will not recover even when the free memory exceeds the safety value.
Therefore, do not disable this function if not necessary.
After the above configuration, you can use the display command in any view to
display and verify the route capacity configuration.
Table 317 Display route capacity configuration
Operation
Display memory occupancy of a
switch
Display the route capacity
related memory setting and
state information
Command
system-view
memory { safety safety-value |
limit limit-value }*
Command
system-view
memory auto-establish
enable
memory auto-establish
disable
Command
display memory [ unit
unit-id ]
display memory limit
Description
-
Optional
safety-value defaults to 40
and limit-value defaults to
30.
Description
-
Optional
By default, automatic protocol
connection recovery is enabled.
Optional
Perform this configuration with caution.
Description
Optional
Optional