3Com 7757 Configuration Manual page 526

526 C 49: AAA & RADIUS & HWTACACS C
HAPTER
c
Configuring RADIUS
Accounting Servers
ONFIGURATION
Table 408 Configure RADIUS authentication/authorization server
Operation
Set the IP address and port
number of the secondary RADIUS
authentication/authorization
server
CAUTION:
The authentication response sent from the RADIUS server to the RADIUS client
■
carries the authorization information. Therefore, no separate authorization
server can be specified.
In an actual network environment, you can either specify two RADIUS servers
■
as the primary and secondary authentication/authorization servers respectively,
or specify only one server as both the primary and secondary
authentication/authorization servers.
The IP address and port number of the primary authentication server used by
■
the default RADIUS scheme "system" are 127.0.0.1 and 1645.
Table 409 Configure RADIUS accounting server
Operation Command
Enter system view system-view
Create a RADIUS radius scheme
scheme and enter its radius-scheme-name
view
Set the IP address and primary accounting
port number of the ip-address [ port-number ]
primary RADIUS
accounting server
Set the IP address and secondary accounting
port number of the ip-address [ port-number ]
secondary RADIUS
accounting server
Enable stop-accounting-buffer
stop-accounting enable
packet buffering
Set the maximum retry stop-accounting
number of retry-times
transmission attempts
of the buffered
stop-accounting
packets.
Set the maximum retry realtime-accounting
number of real-time retry-times
accounting request
attempts
Command Description
secondary Optional
authentication
By default, the IP address and UDP
ip-address
port number of the secondary
[ port-number ]
server are 0.0.0.0 and 1812
respectively.
Description
-
Required
By default, a RADIUS scheme named
"system" has already been created in
the system.
Required
By default, the IP address and UDP port
number of the primary accounting
server are 0.0.0.0 and 1813.
Optional
By default, the IP address and UDP port
number of the secondary accounting
server are 0.0.0.0 and 1813.
Optional
By default, stop-accounting packet
buffering is enabled.
Optional
By default, the system tries at most 500
times to transmit a buffered
stop-accounting request.
Optional
By default, the maximum number of
real-time accounting request attempts
is 5. After that, the user connection is
cut down.