3Com 7757 Configuration Manual page 384

384 C 37: IP R
HAPTER OUTING
P C
OLICY ONFIGURATION
Network diagram
Figure 87 Filter routing information received
Static 20 .0.0.0/8
30 .0.0.0 /8
40 .0.0.0 /8
Vlan -Int 200
12.0.0.1 /8
Switch A
Router ID:
Configuration procedure
1 Configure SwitchA:
# Configure the IP addresses of the interfaces.
<SwitchA> system-view
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 10.0.0.1 255.0.0.0
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ip address 12.0.0.1 255.0.0.0
[SwitchA-Vlan-interface200] quit
# Configure three static routes.
[SwitchA] ip route-static 20.0.0.1 255.0.0.0 12.0.0.2
[SwitchA] ip route-static 30.0.0.1 255.0.0.0 12.0.0.2
[SwitchA] ip route-static 40.0.0.1 255.0.0.0 12.0.0.2
# Enable the OSPF protocol and specify the ID of the area to which the interface
10.0.0.1 belongs.
<SwitchA> system-view
[SwitchA] router id 1.1.1.1
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.0.0.0 0.255.255.255
[SwitchA-ospf-1-area-0.0.0.0] quit
[Switch-ospf-1]quit
# Configure an ACL.
[SwitchA] acl number 2000
[SwitchA-acl-basic-2000] rule deny source 30.0.0.0 0.255.255.255
[SwitchA-acl-basic-2000] rule permit source any
[SwitchA-acl-basic-2000] quit
# Configure a route-policy.
[SwitchA] route-policy ospf permit node 10
[SwitchA -route-policy] if-match acl 2000
[SwitchA -route-policy] quit
10.0.0 .2/8
10.0.0.1 /8
Vlan-Int 100
1 .1.1.1
Area 0
Switch B
Router ID:
2 .2.2.2