3Com 7757 Configuration Manual page 877

n
Remote-ping Client
Configuration
n
Remote-ping server configuration tasks
Table 692 Remote-ping server configuration tasks
Item
Enable the remote-ping server
function
Configure a listening service
on the remote-ping server
Remote-ping server configuration
Table 693 describes the configuration on remote-ping server, which is the same for
remote-ping test types that need to configure remote-ping server.
Table 693 Remote-ping server configuration
Operation
Enter system view
Enable the remote-ping server
function
Configure a UDP listening
service
Configure a TCP listening
service
The remote-ping server function is needed only for jitter, TCP, and UDP tests.
■
You can configure multiple TCP/UDP listening services on one remote-ping
■
server, with each listening service corresponding to a specific destination IP
address and port number.
Remote-ping client configuration
After remote-ping client is enabled, you can create multiple test groups for
different tests, without the need to enable remote-ping client repeatedly for each
test group.
Different types of remote-ping tests are somewhat different in parameters and
parameter ranges. The following text describes the configuration on remote-ping
client for different test types.
Among the test types supported by remote-ping, only the ICMP test can be
performed when IRF fabric is enabled; all other test types cannot be performed
when IRF fabric is enabled. With IRF fabric enabled, you are allowed to configure
remote-ping tests and use the display commands to check your configurations,
Description
The remote-ping server
function is needed only for
jitter, TCP, and UDP tests.
You can configure multiple
TCP/UDP listening services on
one remote-ping server, with
each listening service
corresponding to a specific
destination IP address and
port number.
Command
system-view
remote-ping-server enable
remote-ping-server
udpecho ip-address
port-num
remote-ping-server
tcpconnect ip-address
port-num
Remote-ping Configuration
Related section
"Remote-ping server
configuration"
"Remote-ping server
configuration"
Description
-
Required
Disabled by default.
Required for UDP and jitter
tests
By default, no UDP listening
service is configured.
Required for TCP tests
By default, no TCP listening
service is configured.
877