Displaying Rmon; Rmon Configuration Example - 3Com 7757 Configuration Manual

750 C 69: RMON C
HAPTER

Displaying RMON

RMON Configuration
Example
ONFIGURATION
Table 599 Configure RMON
Operation
Add a statistics entry
n
The rmon alarm and rmon prialarm commands take effect on existing nodes
■
only.
For each port, only one RMON statistics entry can be created. That is, if an
■
RMON statistics entry is already created for a given port, creation of another
entry with a different index for the same port will not succeed.
After the above configuration, you can execute the display command in any view
to display the RMON running status, and verify the effect of the configuration.
Table 600 Display RMON
Operation
Display RMON statistics
Display RMON history
information
Display RMON alarm
information
Display extended RMON
alarm information
Display RMON events
Display RMON event logs
Network requirements
Ensure that the SNMP agents are correctly configured before performing
■
RMON configuration.
The switch to be tested has a configuration terminal connected to its console
■
port and is connected to a remote NMS through Internet. Create an entry in
the Ethernet statistics table to make statistics on the Ethernet port performance
for network management.
Network diagram
Figure 191 Network diagram for RMON configuration
Console port
Command
rmon statistics entry-number
[ owner text ]
Command
display rmon statistics
[ interface-type
interface-number ]
display rmon history
[ interface-type
interface-number ]
display rmon alarm
[ entry-number ]
display rmon prialarm
[ prialarm-entry-number ]
display rmon event
[ event-entry ]
display rmon eventlog
[ event-entry ]
Network port
Switch
Description
Optional
Description
The display command can be
executed in any view
Internet
NMS