3Com 7757 Configuration Manual page 915

Table 709 Configure an assistant edge node
Operation
Enter system view
Create an RRPP domain,
and enter RRPP domain
view
Specify a control VLAN
for the RRPP domain
Specify the current
switch as a transit node
of the primary ring, and
specify the primary port
and the secondary port
Specify the current
switch as an assistant
edge node of the
subring, and specify a
common port and an
edge port
Enable the primary ring
Enable the subring
Return to system view
Enable RRPP
Display the brief
information of all RRPP
domains configured on
the switch
Display RRPP
configuration details on
the switch
Display the RRPP packet
statistics on the switch
Clear the RRPP statistics
information
To clear the RRPP statistics information, use the reset rrpp statistics domain
domain-id [ ring ring-id ] command.
c
CAUTION:
The control VLAN of an RRPP domain cannot be a static VLAN already created
■
on the switch. If you configure a dynamic VLAN as the control VLAN of an
RRPP domain, the VLAN becomes a static VLAN automatically.
You are not recommended to configure a VLAN as both an RRPP control VLAN
■
and a remote-probe VLAN. (Refer to "Mirroring Configuration" on page 685
for information about remote-probe VLAN.)
You are not recommended to configure a VLAN as both an RRPP control VLAN
■
and an isolate-user-VLAN/sub VLAN. (Refer to "Isolate-User-VLAN
Configuration" on page 113 and "Configuring a Sub VLAN" on page 122.)
Assistant Edge Node Configuration
Command
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode transit
[ primary-port pri-port ]
[ secondary-port sec-port ] level
level-value
ring ring-id node-mode assistant-edge
[ common-port comm-port ]
[ edge-port edge-port ]
ring ring-id enable
ring ring-id enable
quit
rrpp enable
display rrpp brief
display rrpp verbose domain
domain-id [ ring ring-id ]
display rrpp statistics domain
domain-id [ ring ring-id ]
reset rrpp statistics domain domain-id
[ ring ring-id ]
915
Description
-
Required.
The command prompt
of RRPP domain view
depends on the
domain-id you input.
Required
Required.
Level 0 identifies the
primary ring and level 1
identifies a subring.
Required
Required
Required
-
Required
Optional.
You can execute the
display command in
any view
Optional
You can execute the
reset command in user
view.