3Com 7757 Configuration Manual page 436

436 C 43: IGMP S
HAPTER
Configuring IGMP
Snooping Simulated
Joining
c
C
NOOPING ONFIGURATION
Generally, hosts running IGMP respond to the IGMP query messages of the IGMP
querier. If hosts fail to respond for some reason, the multicast router may consider
that there is no member of the multicast group on the local subnet and remove
the corresponding path.
To avoid this from happening, you can configure a port of the IGMP-enabled VLAN
interface as a multicast group member. When the port receives IGMP query
messages, the simulated member host will respond. As a result, the subnet
attached to the Layer 3 interface can continue to receive multicast traffic.
Through this configuration, the following functions can be implemented:
When an Ethernet port is configured as a simulated member host, the
■
simulated host sends an IGMP report through this port. Meanwhile, the
simulated host sends the same IGMP report to itself and establishes a
corresponding IGMP entry based on this report.
When receiving an IGMP general query, the simulated host responds with an
■
IGMP report. Meanwhile, the simulated host sends the same IGMP report to
itself to ensure that the IGMP entry does not age out.
When the simulated joining function is disabled on an Ethernet port, the
■
simulated host sends an IGMP leave message.
Therefore, to ensure that IGMP entries will not age out, the port must receive
IGMP general queries periodically.
Configuring IGMP Snooping simulated joining in VLAN interface view
Table 347 Configure IGMP Snooping simulated joining in VLAN interface view
Operation
Enter system view
Enter interface view
Configure one or more ports
in the VLAN as simulated
member host(s) of the
specified multicast group
Configuring IGMP Snooping simulated joining in Ethernet port view
Table 348 Configure IGMP Snooping simulated joining in Ethernet port view
Operation
Enter system view
Enter Ethernet port view
Configure the port in the
specified VLAN as a simulated
member host of the specified
multicast group
CAUTION:
Before configuring IGMP Snooping simulated joining, you must enable IGMP
■
Snooping in VLAN interface view first.
Command
system-view
interface Vlan-interface interface-number -
igmp host-join group-address [ source-ip
source-address ] port interface-list
Command
system-view
interface interface-type
interface-number
igmp host-join
group-address [ source-ip
source-address ] vlan vlan-id
Description
-
Optional
Disabled by
default
Description
-
-
Optional
Disabled by default