Displaying And Maintaining Static Routes; Static Route Configuration Example; Basic Static Route Configuration Example - 3Com 4510G Configuration Manual

Network requirements
To detect the reachability of a static route's nexthop through a Track entry, you need to create a Track
first. For detailed Track configuration procedure, refer to Track Configuration in the System Volume.
Configuration procedure
Follow these steps to detect the reachability of a static route's nexthop through Track:
To do...
Enter system view
Associate the static
route with a track entry
To configure this feature for an existing static route, simply associate the static route with a track
entry. For a non-existent static route, configure it and associate it with a Track entry.
If a static route needs route recursion, the associated track entry must monitor the nexthop of the
recursive route instead of that of the static route; otherwise, a valid route may be mistakenly
considered invalid.

Displaying and Maintaining Static Routes

To do...
Display the current
configuration information
Display the brief information of
the IP routing table
Display the detailed
information of the IP routing
table
View information of static
routes
Delete all the static routes

Static Route Configuration Example

Basic Static Route Configuration Example

Network requirements
The IP addresses and masks of the switches and hosts are shown in the following figure. Static routes
are required for interconnection between any two hosts.
Use the command...
system-view
ip route-static dest-address { mask | mask-length }
next-hop-address track track-entry-number [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
Use the command...
display current-configuration
display ip routing-table
display ip routing-table verbose
display ip routing-table protocol static
[ inactive | verbose ]
delete static-routes all
2-4
Remarks
—
Required
Not
configured by
default
Remarks
Available in
any view
Available In
system view