Configuring SNMP
Basic Functions
Table 594 Common MIBs
MIB attribute
MIB content
Private MIB
DHCP MIB
DHCP MIB
QACL MIB
ADBM MIB
IGMP Snooping MIB
RSTP MIB
VLAN MIB
Device management
Interface management
QACL MIB
ADBM MIB
RSTP MIB
VLAN MIB
Device management
Interface management
The configuration of SNMP V3 configuration is different from that of SNMP V1
and SNMP V2C, therefore SNMP basic function configurations for different
versions are introduced respectively. For specific configurations, refer to Table 595
and Table 596.
Table 595 Configure SNMP basic functions for SNMP V1 and SNMP V2C
Operation
Enter system view
Enable SNMP Agent
Set system information
Configuring SNMP Basic Functions
Command
system-view
snmp-agent
snmp-agent
sys-info { contact
sys-contact | location
sys-location | version { { v1 |
v2c | v3 }* | all } }
741
References
-
-
-
-
-
-
-
Description
-
Optional
By default, SNMP Agent is
disabled
To enable SNMP Agent,
you can execute this
command or those
commands used to
configure SNMP Agent
features
Required
By default, the contact
information for system
maintenance is "3Com
Corporation", the system
location is "Marlborough,
MA", and the SNMP
version is SNMP V3