3Com 7757 Configuration Manual page 696

696 C 62: M
HAPTER IRRORING
Configuring Local Traffic
Mirroring
C
ONFIGURATION
[SW7750] mirroring-group 1 remote-destination
[SW7750] mirroring-group 1 monitor-port GigabitEthernet 2/0/2
[SW7750] mirroring-group 1 remote-probe vlan 10
[SW7750] display mirroring-group remote-destination
mirroring-group 1:
monitor port: GigabitEthernet2/0/2
Configuration prerequisites
ACLs for identifying traffics have been defined. For defining ACLs, see "ACL
■
Configuration" on page 637.
The destination port has been defined.
■
The port on which to perform traffic mirroring configuration and the direction
■
of traffic mirroring has been determined.
Configuration procedure
Table 559 Configure traffic mirroring in Ethernet port view
Operation
Enter system view
Create a mirroring group
Define the destination port
Enter Ethernet port view of
the source port
Enter QoS view
Reference ACLs for identifying
traffic flows and perform
traffic mirroring for packets
that match.
Display the parameter settings
of traffic mirroring
Display all QoS settings of a
port
acl-rule: Applied ACL rules, the following table describes the ACL combinations.
Table 560 Combined application of ACLs on I/O Module other than A type.
Combination mode
Apply all rules in an IP type ACL separately
Apply one rule in an IP type ACL separately
Apply all rules in a link type ACL separately
type: remote-destination
remote-probe vlan: 10
Command
system-view
mirroring-group group-id
local
mirroring-group group-id
monitor-port monitor-port
interface interface-type
interface-number
qos
mirrored-to inbound
acl-rule [ system-index
system-index ] { interface
interface-type
interface-number |
mirroring-group group-id }
display qos-interface
[ interface-type
interface-number ]
mirrored-to
display qos-interface
[ interface-type
interface-number ] all
Form of acl-rule
ip-group { acl-number | acl-name }
ip-group { acl-number | acl-name } rule
rule-id
link-group { acl-number | acl-name }
status: active
Description
-
Required
Required
LACP must be disabled on the
mirroring destination port and
you are recommended to
disable STP on the mirroring
destination port.
-
-
Required
Optional
These commands can be
executed in any view.