Bims Configuration Example - 3Com 7757 Configuration Manual

800 C 73: BIMS C
HAPTER
Accessing the BIMS
Center as Driven by the
Command
BIMS Configuration
Example
Configuring the BIMS
Device to Access the
BIMS Center Periodically
at Startup
ONFIGURATION
Execute the following command in system view to enable the BIMS device access
the BIMS center immediately.
Table 636 Enable the device to access the BIMS center immediately
Operation
Enter system view
Enable the device to access
the BIMS center immediately
Network requirements
The BIMS device accesses the BIMS center at startup and from then on every 48
hours.
The BIMS center is implemented using the BIMS component of 3Com Quidview
NMS. Its IP address and port number are 10.153.21.97 and 80 respectively.
Configuration procedure
1 Configure the BIMS center
Set the shared key used between the BIMS center and the BIMS device. This
■
shared key must be the same as the one configured on the BIMS device.
Add the BIMS device to the NMS manually or automatically.
■
Manual mode: You enter the device name manually to add this device to
■
the system.
Auto mode: Enable the "Automatically add the device" function and set the
■
shared key between the BIMS center and BIMS device. After that, when the
device accesses the BIMS center, it can be automatically added to the BIMS
center.
Specify the files for upgrade, including configuration file and application.
■
When the device accesses the BIMS center, the BIMS center will judge whether
to use these files to upgrade the files on the device. If yes, the BIMS center
sends these files to the device to upgrade the files on the device
n
For detailed configuration procedures, refer to the part discussing the BIMS
component in Quidview Network Management System User Manual.
2 Configure the BIMS device
# Enter system view.
<SW7750> system-view
# Enable BIMS.
[SW7750] bims enable
bims is enable
# Assign the device a unique identifier ar18-20-907.
[SW7750] bims device-id ar18-20-907
# Configure the shared key used between the BIMS center and device.
Command
system-view
bims request
Description
-
Optional