3Com 7757 Configuration Manual page 81

Prerequisites
Controlling Web Users
by Source IP Addresses
Disconnecting a Web
User by Force
Configuration Example
You need to perform the following two operations to control Web users by source
IP addresses.
Defining an ACL
■
Applying the ACL to control Web users
■
The controlling policy against Web users is determined, including the source IP
addresses to be controlled and the controlling actions (permitting or denying).
Controlling Web users by source IP addresses is achieved by applying basic ACLs,
which are numbered from 2000 to 2999.
Table 39 Control Web users by source IP addresses
Operation Command
Enter system view system-view
Create a basic ACL or acl number acl-number
enter basic ACL view [ match-order { config | auto } ]
Define rules for the rule [ rule-id ] { deny | permit }
ACL [ rule-string ]
Quit to system view quit
Apply the ACL to ip http acl acl-number
control Web users
The administrator can disconnect a Web user by force using the related
commands.
Table 40 Disconnect a Web user by force
Operation Command
Disconnect a Web free web-users { all | user-id
user by force user-id | user-name user-name }
Network requirements
Only the Web users sourced from the IP address of 10.110.100.52 are permitted
to access the switch.
Controlling Web Users by Source IP Address
Description
-
As for the acl number command,
the config keyword is specified by
default.
Required
-
Optional
By default, no ACL is applied for
Web users.
Description
Required
Execute this command in user
view.
81