3Com 7757 Configuration Manual page 892

892 C 81: R
HAPTER EMOTE
n
FTP Test
- C
PING ONFIGURATION
For detailed output description, see the corresponding command manual.
You can perform a remote-ping DHCP test only when no DHCP client is enabled
on any interface. Otherwise, the DHCP Server sends the response to an interface
enabled with the DHCP Client rather than to the source interface, thus resulting in
remote-ping DHCP test failure.
Network requirements
Both the remote-ping client and the FTP server are Switch 7750s. Perform a
remote-ping FTP test between the two switches to test the connectivity to the
specified FTP server and the time required to upload a file to the server after the
connection is established. Both the username and password used to log in to the
FTP server are admin. The file to be uploaded to the server is cmdtree.txt.
Network diagram
Figure 243 Network diagram for the FTP test
remote - ping Client
10 . 1 . 1 . 1 / 8
Switch A
Configuration procedure
Configure FTP Server (Switch B):
■
Configure FTP server on Switch B. For specific configuration of FTP server, refer
to"FTP and TFTP Configuration" on page 803.
Configure remote-ping Client (Switch A):
■
# Enable the remote-ping client.
<7750> system-view
[7750] remote-ping-agent enable
# Create a remote-ping test group, setting the administrator name to
administrator and test tag to FTP.
[7750] remote-ping administrator ftp
# Configure the test type as ftp.
[7750-remote-ping-administrator-ftp] test-type ftp
# Configure the IP address of the FTP server as 10.2.2.2.
[7750-remote-ping-administrator-ftp] destination-ip 10.2.2.2
# Configure the FTP login username.
[7750-remote-ping-administrator-ftp] username admin
# Configure the FTP login password.
[7750-remote-ping-administrator-ftp] password admin
# Configure the type of FTP operation.
[7750-remote-ping-administrator-ftp] ftp-operation put
# Configure a file name for the FTP operation.
10 . 2 . 2 . 2 / 8
IP network
FTP Server
Switch B