3Com 7757 Configuration Manual page 315

Configuring the Cost for
Sending Packets on an
OSPF Interface
Setting OSPF Route
Priority
Configuring OSPF Route
Redistribution
fact, the filter-policy import command filters the routes calculated by OSPF; only
the routes passing the filter can be added to the routing table.
Table 239 Configure the cost for sending packets on an OSPF interface
Operation
Enter system view
Enter interface view
Configure the cost for sending
packets on an OSPF interface
Since multiple dynamic routing protocols may be running on one router, the
problem of route sharing and selection between various routing protocols arises.
The system sets a priority for each routing protocol (which you can change
manually), and when more than one route to the same destination is discovered
by different protocols, the route with the highest priority will take preference over
other routes.
Table 240 Set OSPF route priority
Operation
Enter system view
Enter OSPF view
Set OSPF route priority
Table 241 Configure OSPF route redistribution
Operation
Enter system view
Enter OSPF view
Enable OSPF to redistribute
routes from another routing
protocol
Enable OSPF to filter advertised
routes
Command
system-view
interface interface-type
interface-number
ospf cost value
Command
system-view
ospf [ process-id [ router-id
router-id ] ]
preference [ ase ] value
Command
system-view
ospf [ process-id [ router-id
router-id ] ]
import-route protocol
[ process-id | allow-ibgp ]
[ cost value | type value | tag
value | route-policy
route-policy-name ]*
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [protocol ]
OSPF Route Control 315
Description
-
-
Optional
By default, OSPF calculates
the cost for sending
packets on an interface
according to the current
baud rate on the interface.
For a VLAN interface on
the switch, this value is
fixed at 1.
Description
-
-
Optional
By default, the OSPF route
priority is 10 and the priority
of OSPF ASE is 150.
Description
-
-
Required
By default, OSPF does not
import the routing
information of other
protocols.
Optional
By default, OSPF does not
filter advertised routes.