Gvrp Configuration Example - 3Com 7757 Configuration Manual

158 C 18: GVRP C
HAPTER
GVRP Configuration
Example
Network requirements
Network diagram
Configuration procedure
ONFIGURATION
You need to enable GVRP on the switches to enable dynamic VLAN information
registration and update between the switches.
Figure 42 Network diagram for GVRP configuration
Eth2/0/1
Switch A
Configure switch A.
■
# Enable GVRP globally.
<SW7750> system-view
[SW7750] gvrp
GVRP is enabled globally.
# Configure port Ethernet2/0/1 to be a trunk port and to permit the packets of all
the VLANs.
[SW7750] interface Ethernet2/0/1
[SW7750-Ethernet2/0/1] port link-type trunk
[SW7750-Ethernet2/0/1] port trunk permit vlan all
# Enable GVRP on the trunk port.
[SW7750-Ethernet2/0/1] gvrp
GVRP is enabled on port Ethernet2/0/1.
Configure switch B.
■
# Enable GVRP globally.
<SW7750> system-view
[SW7750] gvrp
GVRP is enabled globally.
# Configure port Ethernet2/0/2 to be a trunk port and to permit the packets of all
the VLANs.
[SW7750] interface Ethernet2/0/2
[SW7750-Ethernet2/0/2] port link-type trunk
[SW7750-Ethernet2/0/2] port trunk permit vlan all
# Enable GVRP on the trunk port.
[SW7750-Ethernet2/0/2] gvrp
GVRP is enabled on port Ethernet2/0/2.
Eth2/0/2
Switch B