Displaying The System Status; System Debugging - 3Com 7757 Configuration Manual

Returning from Current
View to Lower Level
View
Returning from Current
View to User View
Displaying the System
Status

System Debugging

Enabling/Disabling
System Debugging
Table 666 Return from current view to lower level view
Operation
Return from current
view to lower level view
Table 667 Return from current view to user view
Operation
Return from current
view to user view
You can use the following display commands to check the status and
configuration information about the system. For information about protocols and
ports, and the associated display commands, refer to relevant sections.
Table 668 System display commands
Operation Command
Display the current display clock
date and time of the
system
Display the version of display version
the system
Display the information display users [ all ]
about user terminal
interfaces
Display the debugging display debugging [ interface
status interface-type interface-number ]
[ module-name ]
The Ethernet switch provides a variety of debugging functions. Most of the
protocols and features supported by the Ethernet switch are provided with
corresponding debugging functions. These debugging functions are a great help
for you to diagnose and troubleshoot your switch system.
The output of debugging information is controlled by two kinds of switches:
Protocol debugging, which controls whether the debugging information of a
■
protocol is output.
Terminal display, which controls whether the debugging information is output
■
to a user screen.
The relation between the two switches is as follows:
Command
quit
Command
return

Displaying the System Status

Description
This operation will result in exiting
the system if current view is user
view.
Description
The composite key <Ctrl+Z> has
the same effect with the return
command.
Description
You can execute the
display command in any
view
855