3Com 7757 Configuration Manual page 850

850 C 77: B ROM
HAPTER OOT
n
Remote Loading Using
TFTP
c
H S L
AND OST OFTWARE OADING
Figure 227 Upload file s7500.btm to the switch
Step 8: Configure s7500.btm to be the BootROM at reboot, and then restart the
switch.
<SW7750> boot bootrom s7500.btm slot 0
This will update BootRom file on board 0 . Continue? [Y/N] y
Board 0 upgrading BOOTROM, please wait...
Upgrade board 0 BOOTROM succeeded!
<SW7750> reboot
When rebooting the switch, use the file s7500.btm as BootROM to finish
BootROM loading.
2 Loading host software
Loading the host software is the same as loading the BootROM program, except
for that the file to be downloaded is the host software file, and that you need to
use the boot boot-loader command to select the host software at reboot of the
switch.
The steps listed above are performed in the Windows operating system, if you
■
use other FTP client software, refer to the corresponding user's guide before
operation.
Only the configurations steps concerning loading are illustrated here, for
■
detailed description on the corresponding configuration commands, refer to
"FTP and TFTP Configuration" on page 803.
The remote loading using TFTP is similar to that using FTP. The only difference is
that TFTP is used instead off FTP to load software to the switch, and the switch can
only act as a TFTP client.
CAUTION: