Member Device Configuration - 3Com 7757 Configuration Manual

Configuring Interaction
for the Cluster
Member Device
Configuration
Member Device
Configuration Tasks
Building a cluster automatically
Table 571 Enable the cluster function automatically
Operation
Enter system view
Enter VLAN interface
view
Configure the IP
address of the VLAN
interface
Enter cluster view
Configure the rang e
of the IP addresses of
the cluster
Build a cluster
automatically
Table 572 Configure interaction for the cluster
Operation
Enter system view
Enter cluster view
Configure the public FTP server for the
cluster
Configure the TFTP server for the cluster tftp-server ip-address
Configure the logging host for the
cluster
Configure the SNMP host for the cluster snmp-host ip-address
c
CAUTION: For Switch 7750 Ethernet switches, the IP address of the cluster public
FTP/TFTP server must be in the same network segment as that of the Layer-3
interface of management VLAN (VLAN1). Otherwise, member devices cannot
communicate with the cluster public FTP/TFTP server.
Table 573 Member device configuration tasks
Operation
Enable NDP globally and for
specific ports
Enable NTDP globally and for
specific ports
Command
system-view
interface Vlan-interface vlan-id Required
ip address ip-address { mask |
mask-length }
cluster
ip-pool
administrator-ip-address { ip-mas
k | ip-mask-length }
auto-build [ recover ]
Command
system-view
cluster
ftp-server ip-address
logging-host ip-address
Description
Required
Required

Member Device Configuration

Description
-
The Switch 7750 requires you to
configure the IP address of the
Layer 3 virtual interface of VLAN1
before you set up a cluster.
Otherwise, the cluster cannot be
set up.
Required
-
Required
Optional
You can build clusters according
to corresponding prompts
Description
-
Required
Optional
Optional
Optional
Optional
Related section
"Enabling NDP Globally and for
Specific Ports" on page 712
"Enabling NTDP Globally and for
Specific Ports" on page 712
711