3Com 7757 Configuration Manual page 926

926 C 84: S
HAPTER MART
Configuring Associated
Devices
L C
INK ONFIGURATION
Table 715 Configure Smart Link (with ports as the members of the Smart Link group)
Operation
Enter system view
Create a Smart Link group
and enter Smart Link group
view
Enable the function of
sending flush messages in the
specified control VLAN
Configure a Smart Link
port as a group view
Smart Link
group
Ethernet port
member
view
Table 716 Configure Smart Link (with link aggregation groups are the members of the
Smart Link group)
Operation
Enter system view
Create a Smart Link group
and enter Smart Link group
view
Configure a link aggregation
group as a member of the
Smart Link group
Enable the function of
sending flush messages in the
specified control VLAN
An associated device mentioned in this document refers to a device that supports
Smart Link and locally configured to process flush messages received from the
specified control VLAN so as to work with the corresponding Smart Link device. As
shown in Figure 257, all the devices including Switch C, Switch D, and Switch E on
the active and backup links connecting the Smart Link device (Switch A) and the
target uplink device (Switch E) are all associated devices.
However, you do not have to enable all the ports of an associated device to
process flush messages received from the specified control VLAN. You need to
enable this function only on the ports that are on the active and backup links
connecting the Smart Link device and the target device. As shown in Figure 257,
you need to enable this function on Ethernet 2/0/2 and Ethernet 2/0/3 of Switch
C, Ethernet 2/0/2 and Ethernet 2/0/3 of Switch D, and Ethernet 12/0/1 and
Ethernet 2/0/12 of Switch E.
Command
system-view
smart-link group group-id
flush enable control-vlan
vlan-id
port interface-type
interface-number { master |
slave }
quit
interface interface-type
interface-number
port smart-link group
group-id { master | slave }
Command
system-view
smart-link group group-id
link-aggregation group
group-id { master | slave }
flush enable control-vlan
vlan-id
Remarks
-
Required
Required
By default, no control VLAN
for sending flush messages is
specified.
Required
Use either approach
Remarks
-
Required
Optional
Optional
By default, no control VLAN
for sending flush messages is
specified.