Configuration Example
Configuring Rate Limit
on Ports
Configuration
Prerequisites
Configuration Procedure
Table 541 Non-type-A I/O Modules' ways of applying combined ACLs
ACL combination
Apply all the rules in an IP ACL separately
Apply a rule in an IP ACL separately
Apply all the rules in a Link ACL separately
Apply a rule in a Link ACL separately
Apply all the rules in a user-defined ACL
separately
Apply a rule in a user-defined ACL separately
Apply a rule in an IP ACL and a rule in a Link
ACL at the same time
Ethernet 2/0/1 of the switch is accessed into the 10.1.1.1/24 network segment
■
Remark the DSCP precedence of the traffic from the 10.1.1.1/24 network
■
segment to 56
Configuration procedure:
<SW7750> system-view
[SW7750] acl number 2000
[SW7750-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[SW7750-acl-basic-2000] quit
[SW7750] interface Ethernet 2/0/1
[SW7750-Ethernet2/0/1] qos
[SW7750-qosb-Ethernet2/0/1] traffic-priority inbound ip-group 2000 dscp 56
The ports where rate limit is to be performed is specified
■
The target rate is specified
■
Table 542 Configure rate limit on ports
Operation
Enter system view
Enter Ethernet port view
Enter QoS view
Configure port-based rate
limit
Display the precedence of the
protocol packet
Configuring Rate Limit on Ports
Form of the acl-rule argument
ip-group { acl-number | acl-name }
ip-group { acl-number | acl-name } rule
rule-id
link-group { acl-number | acl-name }
link-group { acl-number | acl-name } rule
rule-id
user-group { acl-number | acl-name }
user-group { acl-number | acl-name } rule
rule-id
ip-group { acl-number | acl-name } rule
rule-id link-group { acl-number | acl-name }
rule rule-id
Command
system-view
interface interface-type
interface-number
qos
line-rate [ kbps ] target-rate
display protocol-priority
671
Description
-
-
-
Required
Optional
You can execute the display
command in any view