Omron L User Manual page 8

The ZX-LD , ZX-LD
2 Laser Products according to EN 60825-1 (IEC 60825-1) and Class II Laser Products
according to FDA (21 CFR1040.10) (see note). The ZXLT
1 and Class II Laser Products, respectively. The ZX Series is meant to be built into final
system equipment. Pay special attention to the following precautions for the safe use of
the product:
Note: Europe: Class 1 and Class 2 of EN 60825-1: 1994 +A11:1996 +A2:2001
= IEC 60825-1:1993 +A1:1997 +A2:2001
U.S.A.: Class I and Class II of FDA (21 CFR1040.10)
As for the Laser Product Classifications, refer to the Appendix,
p.155
(1) ZX-LD /ZX-LD30V
laser.
Make sure that the laser beam path is terminated. If specular objects are present
in the laser beam path, make sure that they are prevented from reflecting the
laser beam.
When used without an enclosure, make sure the laser path from eye level is
avoided.
(2) To avoid exposure to hazardous laser radiation, do not displace nor remove the
protective housing during operation, maintenance, and any other servicing.
(3) As for countries other than those of Europe and the U.S.A., observe the
regulations and standards specified by each country.
(4) Label Indications
The EN and FDA labels are supplied with the product.
Replace the current labels with them according to the instructions given in the
manuals.
L, ZX-LD V, and ZX-LD
emits visual laser beam. Do not stare directly into the
Introduction
VL Sensor Heads are Class
Sensor Heads are Class
ZX-L-N
User's Manual
vii