Initializing Settings Data; Default Value - Omron L User Manual

Initializing Settings Data

This function resets all settings to their default values.

Default Value

Functions
No. of samples to average
Hysteresis width
Hold
Timer
Special functions
Scaling
Monitor focus
Linear output correction
Display reverse
ECO mode
Display digit limit
Non-measurement settings
Zero reset memory
HIGH threshold
LOW threshold
Standard received light
amount setting
Intensity mode
Differentiation function
Zero reset function
Sub-display
Gain switching
Auto scale
When Reflective type sensor head (ZX-LD) is connected: 256
When Through-beam type sensor head (ZX-LT) is connected: 32
Reflective type sensor head: 1% of rated measuring range
Example: In the case of ZX-LD40, the measuring range is 20 to 50mm. Therefore,
the rated measuring range will be 20mm, resulting in hysteresis width of
0.2mm (1% of 20mm).
Through-beam type sensor head: 0.5% of detection width (F.S.)
Example: In the case of ZX-LT005, the detection width (F.S.) is 5mm. Therefore,
the hysteresis width will be 25µm (0.5% of 5mm).
OFF
OFF
CLOSE
OFF
Minimum value inside rated measuring range: -4V (for voltage output), 4mA (for
current output)
Maximum value inside rated measuring range: +4V (for voltage output), 20mA (for
current output)
No correction
OFF
OFF
5 digits (all)
KEEP
OFF
Maximum display value
Minimum display value
OFF
OFF
OFF
Released
Threshold
When Reflective type sensor head (ZX-LD) is connected: AUTO
When Through-beam type sensor head (ZX-LT) is connected: WHITE
100-L (Only when Through-beam type sensor head (ZX-LT) is connected)
AUXILIARY FUNCTIONS
Default Value
Section 6
ZX-L-N
123
User's Manual