Inputting Numeric Values - Omron L User Manual

Section 3
BASIC OPERATION

Inputting Numeric Values

This section describes how to input numeric values for threshold and output settings.
The example of direct input of the low threshold value will be used.
Changing the low threshold from 40,000 to 39,000
Moving to T Mode
1.
Set the mode switch to T.
Setting Threshold Values
2.
Set the switch to L.
The measured value will be displayed on the main
display.
The current setting will be displayed on the sub-display.
3.
Press any Cursor Key.
The first digit on the sub-display will flash and direct input
will be enabled.
4.
Use the UP and DOWN Keys to display 3.
5.
Use the LEFT or RIGHT Key to move the
cursor to the one's digit.
6.
Use the UP and DOWN Keys to display 9.
To cancel the selected setting, use the LEFT Key to
move the cursor to the leftmost digit and press the LEFT
Key again. Alternatively, use the RIGHT Key to move to
the rightmost digit and press the RIGHT Key again. The
display will return to the current setting (40.000 in this
example).
7.
Press the ENT Key to confirm the setting.
The display will change from flashing to being lit
continuously and the numeric value will be registered.
ZX-L-N
38
User's Manual
RUN T FUN
H L
LD ON
SUB
SUB
SUB
SUB
SUB
SUB
ZERO ENABLE
(mm)