Omron L User Manual page 118

10.
Press the ENT Key to confirm the setting.
The correction value for the first point will be confirmed.
The screen for setting the second point correction value
will be displayed.
Setting the Second Point (B)
11.
Use the same procedure as the first point to
set the correction value for the second point.
12.
Press the ENT Key.
Confirming Setting Results
If linear output correction has been registered correctly,
the sub-display will show [OK].
If not, the display will show [NG].
Check that the current (or voltage) value for the two
points are not the same and execute again.
Section 5
DETAILED SETTINGS
LD ON ZERO ENABLE
(mm)
SUB
LD ON ZERO ENABLE
(mm)
SUB
LD ON ZERO ENABLE
(mm)
SUB
ZX-L-N
User's Manual
101