Reading Displays - Omron L User Manual

Reading Displays

The data displayed on the main and sub-displays depends on the mode currently
selected. RUN mode has been selected prior to shipment from the factory.
When the power is turned ON, the type of amplifier unit and then the number of
channels will be displayed on the main display.
The software version will be displayed on the sub-display.
They are displayed for approx. three seconds, and then data for each mode will be
displayed.
Main Display
Sub-display
Mode Main Display
RUN Displays the measured value (the value
after the measurement conditions have
been reflected).
For example, when the hold function is
set, the held value will be displayed.
T Displays the measured value (the value
after the measurement conditions have
been reflected).
For example, when the hold function is
set, the held value will be displayed.
FUN Displays the function names in order
when the Control Keys are pressed.
Function Transition Charts p.39
LD ON
Displays the threshold value, voltage, current, received
light amount, resolution and present value in order when
the Control Keys are pressed.
Threshold Value Display
Displays either the HIGH or LOW threshold value,
depending on the position of the threshold switch.
Displays the threshold value for the threshold being set.
Displays either the HIGH or LOW threshold value,
depending on the position of the threshold switch.
Displays the setting for the function displayed on the
main display.
BASIC OPERATION
Sub-display
H L
H L
Section 3
ZX-L-N
35
User's Manual