Connections - Omron L User Manual

Connections

This section describes how to connect component parts of the Smart Sensor.
Before connecting/disconnecting Smart Sensor components, make sure that the power to the Amplifier Unit
is turned OFF. The Smart Sensor may malfunction if components are connected or removed while the power
is ON.
Sensor Head
Do not touch the terminals inside the connector.
Connecting the Reflective Type Sensor Head
Push the Sensor Head connector into the Amplifier Unit connector until it locks.
Connecting the Through-beam Type Sensor Head
1.
Push the emitter and receiver connectors into the connectors (×2) of the Sensor Head
- Amplifier Unit connecting cable until they lock.
Connect the emitter to the gray cable.
Connect the receiver to the black cable.
When connecting the Sensor Head, take care not to cause static electricity on the connectors.
PREPARATION FOR MEASUREMENT
Section 2
ZX-L-N
21
User's Manual