Section 7
APPENDIX
Communication with the Smart Monitor is
possible via the Interface Unit
This section describes how to connect Amplifier Units to the personal computer using an
interface unit (ZX-SF11) to enable use of Smart Monitor (ZX-SW11).
1.
Install the Smart Monitor to the personal computer.
2.
Check that the current/voltage switch on the
base of the Interface Unit is set to the side
that has no tab (default).
3.
Set the Amplifier Unit to RUN mode.
Switching Modes p.34
4.
Connect the Interface Unit and personal computer with a cable.
To connect them, use a 9-pin D-sub cross cable (female to female).
p.142
5.
Connect the Interface Unit to the Amplifier Unit.
Use of a calculation unit (ZX-CAL2) allows connection of up to five Amplifier Units.
If you want to connect Amplifier Units of different types, such as ZX-LDA11-N/41-N and ZX-E series,
contact your OMRON representative.
ZX-L-N
144
User's Manual
Connection Method p.26
Side with no tab