Basic Configuration - Omron L User Manual

Section 2
PREPARATION FOR MEASUREMENT

Basic Configuration

The basic configuration of the ZX-L series Smart Sensors is shown below.
ZX-L series Smart Sensors are not compatible with other ZX series Smart Sensors. ZX-L cannot be used
with ZX-E, ZX-W and ZX-T series Smart Sensors.
Smart Monitor
(Software)
ZX-SW11
(Ver 3.0 or later)
Enables operation of
Amplifier Units from
the personal computer
and monitoring
measured values.
Personal
Computer
Connecting Cable
Commercially
available cross cable
p.142
Interface Unit
ZX-SF11
(Ver 2.0 or later)
Used to connect to a
personal computer
or programmable
controller.
p.26
ZX-L-N
10
User's Manual
Basic Configuration
Sensor Head
ZX-LD
ZX-LT
Detects the
sensing object.
p.18
Amplifier Unit
ZX-LDA11-N (NPN type)
ZX-LDA41-N (PNP type)
Performs measurements and
outputs measurement results.
p.16
Power Supply
DC12 to 24V (±10%)
Extension
Cable
ZX-XC1A(1m)
ZX-XC4A(4m)
ZX-XC8A(8m)
ZX-XC9(9m)
To be used between
a Sensor Unit and
Amplifier Unit.
Only one extension
cable can be used.
ZX-XC9 can be used
for ZX-LD only.
Calculating
Unit
ZX-CAL2
Used to connect two
or more Amplifier
Units.
• Calculation
• Mutual interference
prevention
p.24