Omron L User Manual page 110

Setting Threshold Values
3.
Start measurement.
Measurement will continue while the ENT and RIGHT
Keys are held down.
[AUTOT] will flash on the sub-display.
4.
Release the ENT and RIGHT Keys to end
measurement.
The maximum measured value during the measurement
period will be set as the HIGH threshold value and the
minimum will be set as the LOW threshold value.
The new threshold value (either HIGH or LOW,
depending on the threshold switch setting) will be
displayed on the sub-display.
When ERRLH is displayed p.89
The threshold values set using automatic teaching can be changed using direct input. This is useful
when setting judgement tolerances for measured values.
p.89
Section 5
DETAILED SETTINGS
LD ON ZERO ENABLE
(mm)
SUB
SUB
ZX-L-N
User's Manual
93