Use Of The Field Entry Controls - BRUEL & KJAER 2032 Instruction Manual

In a dual trace format, two DISPLAY SETUPs are shown, and the Field Selector can be
moved between the two, and pressing SETUP LABEL "Display" once moves the Field
Selector to the label field of whichever DISPLAY SETUP in which it was previously
placed. Pressing the pushkey further toggles the Field Selector between the two DIS-
PLAY SETUP label fields. Similar principles apply to the CURSOR push key, for exam-
ple:
Cursor
Cursor
~----~~1------~1 1
m m
3.3.2. Use of the FIELD ENTRY Controls
16
When the required parameter has been accessed using the FIELD SELECT controls, its
value can be entered using any of three different methods:
~--Field Entry-----.
1. Step-by-Step Parameter Entry
••
a m
These two pushkeys are used to increment or decrement the chosen parameter with
the smallest allowable step. When they are held down continuously, the parameter is
incremented or decremented repeatedly. The parameter value cannot be moved out-
side its allowed range, nor can an illegal parameter setting, (that is one which has no
meaning for the selected MEASUREMENT, DISPLAY, or CURSOR SETUP), be selected.
Field Entry
2. Continuous Parameter Entry
Turning the knob to the right with respect to its rest position continuously increments
the parameter value. Turning it to the left continuously decrements the parameter val-
ue. The rate of increment or decrement is proportional to the angle of turn of the knob
and the adjustment range of the selected parameter. The parameter value cannot be
moved outside its allowed range, nor can an illegal parameter setting be selected.