Parameter Entry; Use Of The Field Select Controls - BRUEL & KJAER 2032 Instruction Manual

3.3. PARAMETER ENTRY
The procedure used for the entry of MEASUREMENT, DISPLAY, and CURSOR SETUP
parameters as well as other parameters is always the same:
1. Select the required parameter field using the FIELD SELECT controls.
2. Enter the required parameter value using the FIELD ENTRY controls.
3.3.1. Use of the FIELD SELECT Controls
14
Field Selector
Fig.3.2. The 2032 Display Screen
The selected parameter is indicated on the 2032 Display by an inverse video field
called the Field Selector, see Fig.3.2. The Field Selector is moved around the Display
with the help of 7 FIELD SELECT pushkeys, described below:
......---- Field Select - - - - - ,
II Moves the Field Selector
-
r-1 line up, normally to the
....
~t---------'
first parameter in the line
Moves the Field
Selector_----!..,..~-~
• · - .,. 4 t--_Moves the Field Selector
one field to the left
g j
~
one field to the right
Moves the Field Selector one
_j
line down, normally to the
first parameter in the line
r -
Setup Label ----,
Measurement
Display Cursor
I l l