Table of Contents
Advertisement
X- Y RECORDER 2308
REMOTE 1:
X
-
Y Recorder
Control
Remote 1
~
~
8-pole DIN socket providing the X-output and pen lift signal for an X-
Y Recorder Type 2308. For connection to the REMOTE 1 of a 2308,
use BrOel
&
Kjrer cable part number AQ 0034. The pin connections of
the X- Y RECORDER 2308 REMOTE 1 connector are given in Fig.4.13.
It accepts plug BrOel
&
Kjrer part number
JP 0802. Maximum X-output
voltage 10 V, X-output output impedance
~
1
Q.
Pen Lift
GND
REMOTE 1 (external view)
830659
Fig.4.13.
Pin Connections, 2032 X- Y RECORDER 2308 REMOTE 1
connector, external view
RECORDER
Y-OUTPUT:
Y -Output
OPEN/SHORTED:
&
Signal
Chassis
Ground
Open
Ground
SIGNAL GROUND:
CHASSIS GROUND:
FUSE:
Shorted
Fuse: F
4A
:
100
-
127V
2A:
200
-
240V
•
MAINS VOLTAGE
SELECTOR:
100
-
127V
200
-
240V
•
50
BNC connector providing the Y -output to an X-Y Recorder Type 2308.
Maximum Y-output voltage 10V. Output impedance
~
1
Q.
For connecting signal ground and chassis ground on the 2032. When
the switch is in its downward position, signal and chassis ground are
short circuited.
A
WARNING:
The 2032 is designed to be operated with its signal ground
lines and chassis always at earth potential. Never let the signal
ground terminals, socket screens, or chassis float at any other poten-
tial, as this will impair the operating safety of the 2032 and may dam-
age the instrument.
For external connection to the signal ground of the 2032.
For external connection to the chassis ground of the 2032.
Holds the main fuse of the 2032. To extract, give the fuse holder a
quarter turn anticlockwise, whereby the fuse holder will spring out.
The correct fuse ratings are as follows:
100-127V: 4A Fast Blow
200-240 V : 2A Fast Blow
For selection of the correct mains voltage supply. The maximum al-
lowable variation in the voltage supply from the selected range is
± 10%. The mains voltage frequency should be 50-60Hz, ± 5%
Advertisement
Table of Contents
