Table of Contents
Advertisement
12.
THE UNIVERSAL PARAMETER SELECTOR
12.1. INTRODUCTION
128
Universal Parameters are global system parameters not connected with any particular
MEASUREMENT, DISPLAY or CURSOR
SETUP.
Usually, it will not be necessary to
change them from the parameter value automatically selected on power on. Since Uni-
versal Parameters are seldom used, it is possible to remove the Universal Parameters
Selector fields from the 2032 Display. The position of the Universal Parameter Selector
fields on the 2032 Display is shown in Fig.12.1.
Universal Parameter
Selector
Fig. 12. 1. The Universal Parameter Selector fields
The Universal Parameter Selector fields can only be accessed when the 2032 Display is
set to a single trace format with the MEASUREMENT SETUP. However, they are
not
part of the MEASUREMENT SETUP. The Universal Parameter Selector can be set to
any one of
.
9 settings via the FIELD SELECT and FIELD ENTRY pushkeys. A list of
available settings is as follows, the numbers shown indicating the numeric keyboard
entry codes:
0.
1.
SOUND INTENSITY CALIBRATION
2.
SINE GENERATOR FREQUENCY
3.
SPECIAL PARAMETER
4.
MAIN MEMORY
5.
SCRATCH PAD MEMORY
6.
CONTINUOUS MEMORY
7.
1/0 ADDRESS SWITCH
8.
INTERFACE TERMINATOR
These settings are described in more detail in Section 12.3.
Advertisement
Table of Contents
