Table of Contents
Advertisement
5.
USE OF THE 2032 SOFT CONTROLS
5.1. INTRODUCTION
52
The soft controls of the 2032 are defined as those which are accessed via the 2032
Display using the FIELD SELECT pushkeys. Description of them is divided into four
sections, namely, those associated with the MEASUREMENT SETUP, those associated
with the DISPLAY SETUP, those associated with the CURSOR SETUP, and other con-
trol fields. Wherever possible, the name used for each control field in the description
corresponds with the name, if any, appearing on the 2032 Display.
In the following description, any field shown as
I
I
is user-definable. The allowed
settings of the field are given, as well as the limits of numerical fields. Hidden fields
are indicated, that is those fields which are only visible under certain defined control
setting conditions, as are interlocks between the various fields. An illegal setting in any
field is shown on the 2032 Display by the field starting to blink.
Settings are entered into the user-definable fields either by indexing through the al-
lowed settings or entering the required setting directly via the numeric keyboard. In the
case of numeric keyboard entry the setting entered need not correspond to an allowed
se.
t ting of the field. For instance, the Field Selector could be indexed to the FREQUEN-
CY SPAN field, and 1,4 k entered via the keyboard. Since the entered value does not
correspond to an allowed setting of the field, the 2032 will round it up or down accord-
ingly, and in this example, the 2032 FREQUENCY SPAN field would be set to 1,6 kHz.
Y
18 3d8
SOdS
X
OHz
+
6 4
Measurement
Setup _ _ __.;_
X
1040Hz
I
Cursor
~--setup
Fig.5. 1.
Division of the 2032 Display into MEASUREMENT SETUP,
DISPLAY SETUP, and CURSOR SETUP control fields
Advertisement
Table of Contents
