Table of Contents
Advertisement
as the Main Cursor read-out), or 1 for increased resolution, parameter 2 is the
start element number, and parameter 3 is the stop element number, 0
~
pa-
rameter 2
~
parameter 3
~
maximum element number. Used to output the
cursor values for part of the displayed trace containing the Field Selector.
-1004*:
Actuai_Binary_Function <parameter
1 >,
<parameter
2>,
<parameter
3> -
as Parameter value -
1003,
but giving a read-out in .binary instead of ASCII.
Note: where parameters 1, 2 or 3 are used to define a memory address, the
allowed range is from
0
to
65535
10
(0
to
177777
8 ).
To enter a number greater than
32767
10 ,
first subtract
65536
10
(for example,
32768
10
would be entered as
32768-
65536
=
-32768
10 ,
or
1 00000
8 ).
For further details of all of the above read-out possibilities, refer to the
2032
Main IEC
Interface Manual.
12.7.2. 81: Manual Digital Output Parameter 1
Special Parameter
81
is used to set parameter
1
in a manual digital output, see Sec-
tion
12.7.1.
12.7.3. 82: Manual Digital Output Parameter 2
Special Parameter
82
is used to set parameter
2
in a manual digital output, see Sec-
tion
12. 7.1.
12.7.4. 83: Manual Digital Output Parameter 3
Special Parameter
83
is used to set parameter
3
in a manual digital output, see Sec-
tion
12.7.1.
12.7.5. 84:
R·
e peat Digital Output
144
Special Parameter
84
allows the
2032
to be set to autqmatically repeat a measurement
cycle, with a digital output after each cycle. The Parameter value can be set to 0, 1 or
2.
0:
causes no action
1:
when the
2032
goes to RECORD "Stop", DIGITAL 1/0 "Output" and then RECORD
"Single" are automatically selected. In the event of a read-out error, press RE-
CORD "CONT." and then DIGITAL 1/0 "Stop" to clear the error.
2:
when the
2032
is set to RECORD "Cont." and goes to AVERAGING "Stop", DIGI-
TAL 1/0 "Output" and then AVERAGING "Start" are automatically selected. In the
event of a read-out error, press RECORD "Stop" and then DIGITAL 1/0 "Stop" to
clear the error.
Note: Special Parameter 84 has no influence when Special Parameter 80 is set to
32767.
Advertisement
Table of Contents
