Table of Contents
Advertisement
7.1.3. Selection of the 2032 X-V Recorder Output Writing Speed
Fig. 7.4.
Location of the 2032 X- Y Recorder Output Control Card ZD
0269
.&
WARNING! Disconnect all power from the 2032 before attempting to remove or replace
its protective panels. Internal adjustments with mains power connected should only be
carried out by skilled persons who are aware of the hazards of dealing with live circuit-
ry.
The X- Y Recorder Output from the 2032 is controlled such that it takes place with
constant writing speed. One of five different writing speeds may be chosen as follows:
1.
Disconnect all power supplies before removing any of the protective panels of the
2032. Remove the X- Y Recorder Output Control Card ZD 0269 from the 2032. Its
location is shown in Fig.7.4.
2.
The output writing speed is selected using the dual in-line switches mounted on
the left hand side of the card, (viewed from the component side), shown in Fig.7.5.
The switch pairs are numbered one to five. Each switch pair is enabled by
pres_
s-
ing the right hand switch of the pair, and disabled by pressing the left hand
switch.
107
Advertisement
Table of Contents
