Table of Contents
Advertisement
Binning
The binning function allows you to combine the signal values of clusters of adjacent pixels to create
improved virtual pixels. Using the function results in images with lower pixel resolution and higher
sensitivity.
This camera performs horizontal binning via digital addition or averaging processing.
This camera performs vertical binning via digital addition in the sensor.
RS-232C Command Control
The basic control parameters are as follows.
Item
Scanning
Electronic Shutter
Gain
Black
Trigger
Miscellaneous
Field Upgrade Function
You can update the firmware using the dedicated update tool via Camera Link serial communication.
Serial communication via the DC IN / trigger IN connector (12-pin round) is not supported for this function.
Noise reduction digital filter function
This function reduces noise by applying a 1x3 median filter.
SNR can be improved, but it affects the sense of resolution and sensitivity. An imaging test
should be performed before deciding to use this feature.
This function is enabled when [Media Filter] of [JAI Custom Control] is set to On.
(This function is disabled (Off) by default.)
Control parameter
Independent scanning for all pixels, binning
Accumulation time
Gain value
Black offset value
Mode, trigger polarity selection
Camera Link: 8- ⇔ 10-bit switching
Test pattern: ON ⇔ OFF
— 32 —
SW-8000M-PMCL
Advertisement
Table of Contents
