Control Terminals - Danfoss VLT AQUA Drive FC 202 Operating Manual

Operating Guide | VLT® AQUA Drive FC 202
17 Auxiliary relay for heater (-QAM)
19 Cabinet light/socket outlet protection MCB (-FCC)
21 DC distribution circuit terminal block (-XD3)
23 AC fan supply terminal block set (-XDY)
25 Basic I/O terminal block and option A, B, D card terminal
block set (-XD2)
27 Grounding clamp for the shield termination of wires.
Illustration 41: Layout of Control Compartment Interior with All Options

5.7.3 Control Terminals

Table 25: Serial Communication Terminals
XD2 ter- Parameter
minal
1 –
2 Parameter group 8-3* FC
Port Settings
3 Parameter group 8-3* FC
Port Settings
Table 26: Digital Input/Output Terminal Descriptions
XD2 ter- Parameter
minal
10, 11 –
12 Parameter 5-10 Terminal 18 Digital
Input
13 Parameter 5-11 Terminal 19 Digital
Input
16 Parameter 5-14 Terminal 32 Digital
Input
17 Parameter 5-15 Terminal 33 Digital
Input
14 Parameter 5-12 Terminal 27 Digital
Input
15 Parameter 5-13 Terminal 29 Digital
Input
18 –
68 | Danfoss A/S © 2018.10
18 Contactor control circuit protection MCB (-FC10)
20 Cabinet heater(s) circuit protection MCB (-FCE)
22 Motor heater circuit protection MCB (-FCN)
24 Option C2 terminal block set (-XDF)
26 Door components terminal block set (-XDJ)
Default Description
Setting
– Integrated RC-filter for cable shield. Used only for connecting the shield in
case of EMC problems.
– RS485 interface. A switch (BUS TER.) is provided on the control card for bus
termination resistance. See Illustration 5.22.
–
Default setting
+24 V DC
[8] Start
[10] Reversing
[0] No operation
[0] No operation
[2] Coast inverse
[14] JOG
–
Description
24 V DC supply voltage for digital inputs and external trans-
ducers. Maximum output current 200 mA for all 24 V loads.
Digital inputs.
For digital input or output. Default setting is input.
Common for digital inputs and 0 V potential for 24 V supply.
AQ262141056213en-000101 / 130R0882
Electrical Installation