Service And Maintenance; About Service And Maintenance; Cleaning Of The Cabinet - ABB HVC Installation Manual

HVC 450 kW E-Bus Charger Installation Guide

7. Service and Maintenance

7.1. About Service and Maintenance

E Service and Maintenance
Maintenance is done according the maintenance schedule. This is outside of the scope
of this document.

7.2. Cleaning of the cabinet

The Power Cabinet and ABB Pole is powder coated. This coating must be kept in good
condition.
Clean the Power Cabinet and ABB Pole three times a year in the following way:

Remove rough dirt by spraying with low-pressure tap water.

Apply a neutral or weak alkaline cleaning solution and let it soak.

Remove dirt by hand with a non-woven nylon hand pad.

Rinse thoroughly with tap water.

Optionally, apply wax on the front for extra protection and gloss.

Do a check on the coating for damage.
When the HVC 450 kW E-Bus Charger is exposed to rain, it is sufficient
to clean it twice a year.
Do not apply high-pressure water jets. Water may leak into the Power
Cabinet. If a high-pressure water jet has been used, make sure that the
inside of the Power Cabinet is dry.
- Only use cleaning agents with a pH value between 6 and 8.
- Do not use cleaning agents with abrasive components.
- Do not use abrasive tools.
Revision: 1.2
Date released: 16-08-2018
NOTICE
CAUTION
COMPANY CONFIDENTIAL
Page 111 of 128