Installing An Internal Usb Device - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Installing an internal USB device

Installing an internal USB device
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Plug in the USB device into the USB port.
10. Install the access panel .
11. Install the server into the rack .
12. Connect all peripheral cables to the server.
Installing an internal USB device 187