Installing A Dimm - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Installing a DIMM

Installing a DIMM
CAUTION: CAUTION:
Do not install RDIMMs and LRDIMMs in the same server.
Do not install ×4 and ×8 DRAM widths in the same server.
Attempting to mix any combination of these DIMMs can cause the server to halt during BIOS initialization. All memory
installed in the server must be of the same type.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Prerequisites Prerequisites
If you install a 256 GB or higher capacity DIMM, the high-performance, dual-rotor fans are required .
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the air baffle.
Installing a DIMM 132