CAUTION:
CAUTION:
The optical drive-M.2 SSD SATA splitter cable is only compatible with the NVMe/SATA port 9A. To prevent port
damage and/or server malfunction, do not connect the splitter cable to any other system board port.
16. Do one of the following:
If an optical drive is already installed, release the SSD connectors of the optical drive-M.2 SSD SATA splitter cable, and then
connect them to SSDs.
If an optical drive is not installed, connect the optical drive-M.2 SSD SATA splitter cable to the system board and SSDs .
17. Install the access panel .
18. Install the server into the rack .
19. Connect all peripheral cables to the server.
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. If installed, close the cable management arm.
Installing the M.2 SATA SSD enablement option
166