Table of Contents
Advertisement
Installing an internal USB device
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
•
If the server is in rack mode: Remove the server from the rack.
•
5.
Remove the front bezel.
6.
Remove the access panel.
7.
If installed, remove the air baffle.
8.
Locate the internal USB connector.
9.
Plug in the USB device into the internal USB port.
10. If removed, install the air baffle.
11. Install the access panel.
12. Install the front bezel.
13. Do one of the following:
Hardware options installation
91
Advertisement
Table of Contents
