Preparing The Server For Installation - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Preparing the server Preparing the server for installation
WARNING: WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, disconnect
the power cord to remove power from the server. Pressing the Power On/Standby button does
not shut off system power completely. Portions of the power supply and some internal circuitry
remain active until AC power is removed.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
Procedure Procedure
1. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center website
(https://www.hpe.com/support/hpesc https://www.hpe.com/support/hpesc). To update the system ROM, follow the instructions on the website.
2. Power down the server.
3. If installed, remove the front bezel .
4. Power down the server.
5. If installed, release the cable management arm.
6. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
7. Disconnect all peripheral cables from the server.
8. Remove the server from the rack .
9. Place the server on a flat, level work surface.
10. Remove the access panel .
11. Remove the air baffle.
for installation

Preparing the server for installation

192