Installing the 2 SFF drive cage option
Installing the 2 SFF drive cage option
This server supports two 2 SFF drive cage options. The following drive types are supported:
SATA, SAS, and U.3 NVMe drives
U.2 NVMe drives
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the rack sliding rails.
Installing the 2 SFF drive cage option
107